Guest
Show Posts
1
General Mach Discussion / Re: Absolutley Impressed
« on: April 04, 2006, 11:18:54 AM »
Mine is a servo drive too with 65 pulse Amps/ 132 Volts and Boss 9 software. Is pulse amp the same as Amps or less? I think one of the Axis drive has a problem, red led on DCS Board is lit when powered inspite of interchanging its slot with other drive slot. First I will try to understand the electronics as written in the manuals and if possible try to repair the drive or get it repaired locally. Since I am located in India, it would be much cheaper to get the card repaired rather than replacing it or is there any other problem? I purchased from New Jersey and they even sent screen snapshots to prove that it works properly and the card in which red led is lit up is also consectively numbered which shows that it was not replaced. I have cleaned all the electronics and installed back the cards.
I have downloaded the manual for Mach 2 and started reading the stuff. I think networking the machine with Mach 2 and Mach3 is same with difference in software only.
What minimum hardware is required for R2E4 for interfacing with Mach2/3, using as much of the original as possible?
I have downloaded the manual for Mach 2 and started reading the stuff. I think networking the machine with Mach 2 and Mach3 is same with difference in software only.
What minimum hardware is required for R2E4 for interfacing with Mach2/3, using as much of the original as possible?