Hello Guest it is November 29, 2023, 10:50:26 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - AsaadJ

Pages: 1
General Mach Discussion / Help Needed : Newbie : Auto Tool Z Height issue
« on: December 11, 2018, 05:06:40 AM »
Hi Folks,

I just built my first CNC router. I have a problem where the Z axis is moving very fast down to touch the Auto Z Height plate and then it bounces up! the issue is that it moves too fast to touch the plate?

It was working fine and properly and suddenly this issue appeared?

I don't know what is causing the problem and how it can be fixed.

I am using mm as native measurements, CNCRP machine! Tried to reinstall the Auto tool Z Height script and nothing happened.

Your help is much appreciated.

Pages: 1