Messages

1

General Mach Discussion / Re: G31 won't follow feed rate

« on: November 28, 2018, 04:58:26 AM »

XHC MK4-ET with ethernet interface on a 4 axis machine with a rotary. Turns out they released another driver just a few weeks ago. I installed it yesterday and tested the dooky out of it.  It works fine now

!http://www.cdxhctech.com/html/edownloads/view_304.html

2

General Mach Discussion / Re: G31 won't follow feed rate

« on: November 27, 2018, 05:42:40 AM »

If I set g31 f4 it still feeds down like a rapid.  No matter if Its in g20 or g21. It moves at the same speed.

3

General Mach Discussion / G31 won't follow feed rate

« on: November 27, 2018, 05:23:32 AM »

I've been trying to figure this out for about a week with no leads.

When I first start mach3 the probe z tool feeds nice and slow.  After I run a program the probe z function feeds at full rapid.  Once this happens ref all home also feeds at full rapid.

I've tried changing the feed rate in the macro and it has no effect.