Guest
Show Posts
1
General Mach Discussion / No motors moving...
« on: November 27, 2018, 02:42:22 AM »
Hey Mach community!
Finally got my electronics wired up today! Exciting stuff. I'm using a modern Windows 10 PC, with a PCI-E to Parallel port card, connected to a BOB as per usual. I've got correct pins set up in Mach 3, and serial port seems to match. My steppers are just holding solid, and I can't get any response from my machine. Is there any troubleshooting I can go through to narrow down the problem?
Thanks!
Finally got my electronics wired up today! Exciting stuff. I'm using a modern Windows 10 PC, with a PCI-E to Parallel port card, connected to a BOB as per usual. I've got correct pins set up in Mach 3, and serial port seems to match. My steppers are just holding solid, and I can't get any response from my machine. Is there any troubleshooting I can go through to narrow down the problem?
Thanks!