Hello Guest it is March 28, 2024, 11:11:55 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ducksy

Pages: 1
1
General Mach Discussion / Re: No Motor movements
« on: December 19, 2018, 04:42:14 PM »
Hi Branden

Yes. I have finally have my unit working, believe it or not I was reading my Multimeter wrong, trying to run it on to low a voltage.
I now have torque, and good movement.

Thanks David :D

2
General Mach Discussion / No Motor movements
« on: December 04, 2018, 05:05:27 PM »
Hi People. Just built a homebrew CNC machine with plans from Hobby CNC.

     Installed Mach 3, The program seems to like my computer ran the Driver test program, setup all the correct parameters I think according to the website for their controller, all the wiring checks out.
   
Problem I have is the X axis motor only turns one way,  it sounds good, Y & Z axis do not move at all, though Z axis motor make a noise but does not turn.

Any help appreciated Thanks David.

Pages: 1