Hello Guest it is March 29, 2024, 01:33:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - hismaimai8888

Pages: 1
1
General Mach Discussion / Soft limit setup?
« on: November 13, 2018, 03:34:20 AM »
I need help setting up my values for the soft limit. So when I home reference all it goes to the bottom left corner of my table. If my table goes 30"+ in X, Y directions what would I put as my soft limit values? I don't want it to travel to the left or towards me any further. Is z referenced from the top of the table surface when setting up the soft limit for Z?
Thanks in advance

Pages: 1