Messages

1

Mach3 and G-Rex / Re: Home limite mach3 et G100

« on: February 07, 2008, 08:09:55 AM »

Hello

Here is a picture




JP

2

Mach3 and G-Rex / Re: Home limite mach3 et G100

« on: February 07, 2008, 05:19:16 AM »

Hello
I will try again tomorrow but I think at the time of my last reference tests there is only Z which is working.
 JP

3

Mach3 and G-Rex / Re: Home limite mach3 et G100

« on: February 06, 2008, 03:09:54 PM »

Thanks for your answer. I think I have followed the G100 instructions’handbook to do the installation. I enclose my diagnosis screen capture when the machine stops and at this moment  Mach3 seems to do nothing else ( Z is OK).

Thanks.
Regards.

4

Mach3 and G-Rex / Home limite mach3 et G100

« on: February 04, 2008, 10:59:12 AM »

Hello!
Please find my problem
I use Mach3 and G100 the Mach3 input are configured like that:
XHOME port 1 pin 17
YHOME port 1 pin 18
ZHOME port 1 pin 19

In this case the origins machine works very well, if I add
X+ + port 1 pin 17
Y+ + port 1 pin 18
Z+ + port 1 pin 19

When the machine made the Z-axis origins, the machine going on ZHOME then emerges ZHOME ( so OK), then the Y axis go on YHOME and a this moment nothing happening mach3 seems block but does not errors I must to do a RESET and then mach3 indicates the error limit switch triggered and what’s normal.

I have try many time but no result, Thanks a lot

Ps: the emulated hotkey is not active

Jean Pierre