Hello Guest it is March 28, 2024, 12:06:49 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - maverick1978

Pages: 1
1
General Mach Discussion / Re: Help Can't get steppers to move!!!
« on: October 18, 2018, 12:09:56 AM »
Noted Roger.
I plan to do router table first and want to proceed to laser finally.
Reading the manual will take some time for me.

2
General Mach Discussion / Re: Help Can't get steppers to move!!!
« on: October 17, 2018, 10:17:09 PM »
Thanx again for valuable knowledge.
Please explain me how to fine tune motor control.

3
General Mach Discussion / Re: Help Can't get steppers to move!!!
« on: October 17, 2018, 10:13:13 PM »
Thanx Roger, what other parameters/factors affect stepper speed.

4
General Mach Discussion / Re: Help Can't get steppers to move!!!
« on: October 17, 2018, 09:12:41 PM »
Hi Friend,

There is no model number for board, I bought it from Amazon (Rrimin Mach3 CNC Stepping Motor Driver Interface Adapter Breakout Board +USB Cable)

I worked again last night and by tuning motor control, I got the motor running.

My next query is how to increase the speed of stepper motor? How kernel speed affects it.

5
General Mach Discussion / Re: Help Can't get steppers to move!!!
« on: October 17, 2018, 06:14:07 AM »
Hi Friends,

Totally new to DIY-CNC and need your help and support to run my single motor in X axis (Pul/Dir).

I bought Rhino 10kgcm Nema 23 motor with DM542 stepper driver and trying to drive with 24VDC 14.5Amps power supply and 5 axis optical isolated board from Rrmin (Chinese make).

I did the connections as per general guidelines provided on internet, Everything seems fine but motor is not running.

Please support to figure out what is wrong and how to correct it

Maverick

Pages: 1