Hello Guest it is April 23, 2024, 02:51:29 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - oddname

Pages: 1 2
1
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 28, 2018, 09:18:24 AM »
Simple, home and limit - is the same position I want to use :)  better to just combine then.

2
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 27, 2018, 07:29:32 AM »
Another add-on to my thread.

I am setting up home and + limits for the XY axis, but how to I set that home also = limit -  ?


3
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 17, 2018, 01:04:49 PM »
And all works!!!  It was a little bit of this, a little bit of that.

Biggest issue was using usb over ethernet, works flawlessly now!


Thank you ALL for the great support :)

4
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 12, 2018, 02:02:47 PM »
see motion here;

https://www.youtube.com/watch?v=zQd1yhOI0kk

Not really smooth, just jogging here :)

5
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 12, 2018, 12:51:26 PM »
Well I got thing moving sort of.

All axis working, sort of, with some issues now.

Slave for my 2x motors axis (Y) is only accepting one of the motors, holding torque works, yet no movement.
Is there Another slave-axis bug in the plugin? Read a thread where that was the case of an older version of the plugin.

And motion isnt smooth,  how to fix that, not even during a long jog it seems.

6
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 12, 2018, 04:25:14 AM »
I will try that when back at the machine, I did another test today though, I get sliiight movement, same exact movement no matter which motor, driver and port I use, so the issue is atleast consistent :)
I can get the movement below, but in the exact same range.  So say I move from 4mm to -1 at -1 it switched dir and move x-amount of mm, then  no more no matter which value, then I change direction and when it get backs to -1 it move the other way x-amount of mm.

Se video

https://www.youtube.com/watch?v=zsnJS0QHTQs

7
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 11, 2018, 12:10:28 PM »
Sorry for the delay , but measured Dir. Finally with  something I trust

10mA one dir, 0 for the other

8
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 11, 2018, 09:13:29 AM »
I am more confident now that I will do a successful measurement next, realized just now when looking at a picture, "hey I measured step not dir..." :/

9
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 11, 2018, 05:58:08 AM »
Confirmed working MM in the way over now, so Will do some measurements today /tomorrow

10
PoKeys / Re: Pokeys, mach4 no go?!
« on: October 11, 2018, 04:43:49 AM »
I will measure again, just getting hold of a ammeter I know that works for sure :)

Pages: 1 2