Messages

1

General Mach Discussion / Search Bar Down ?

« on: November 08, 2018, 06:51:50 PM »

Attempting a search brings the message below. Is the search bar active ?

2: pspell_new(): PSPELL couldn't open the dictionary. reason: No word lists can be found for the language "en".
File: /var/www/vhosts/machsupport.com/forum.machsupport.com/forum/Sources/Search.php
Line: 700

2

General Mach Discussion / Re: Noob question about Mach 3 Turn tool DRO #

« on: October 03, 2018, 11:12:41 AM »

That makes total sense. Thank you both.

3

General Mach Discussion / Noob question about Mach 3 Turn tool DRO #

« on: September 28, 2018, 05:53:44 PM »

Hi there,

Is there a way to automatically return the Tool DRO to the Master Tool after finishing a multi tool run.  Couple of times I neglected to reset the Tool DRO back to the master, for the next (repeat) job, which was interesting.....
Phil