Hello Guest it is April 18, 2019, 07:18:35 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Okcsmurf

Pages: 1
1
General Mach Discussion / G Code Question
« on: September 17, 2018, 11:24:22 AM »
G code question
I have a code that makes a square 1.25 inch x 1.25 inch. I adjust the motor tuning setting to get it to 1.25 inch x 1.25 inch
I go to cut a circle that is suppose to be 1.00 it cuts it to 1.75 od. What can be causing this?

2
Share Your GCode / Re: Cutting circle
« on: September 16, 2018, 07:31:19 PM »
does someone have a gcode to cut a circle 1 inch od?

3
Hello I am trying to set up my mill and tuning the motors in mach3.
I have a gcode for 1.25 x 1.25 square, got it dialed in to do that . I got to cut a circle that is 1 inch of and when I cut it does 1.75 of what would cause that?

Pages: 1