Hello Guest it is March 29, 2024, 12:34:24 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - ryghar

Pages: 1
1
Post Processors / Re: Mastercam 2018 Mach3 postprocesor
« on: November 12, 2018, 08:18:19 AM »
Excellent!!

Thanks!!

2
Post Processors / Mastercam 2018 Mach3 postprocesor
« on: November 12, 2018, 07:36:15 AM »
Hello,

Can anyone help me to configure Mastercam 2018 to worrk with Mach3 3axis?
I found a post naming the file Boss_Mach3.txt but I cant find it, the link is broken.

Thank you so much!!!

3
General Mach Discussion / Re: Problem with auto Zero tool
« on: September 17, 2018, 09:55:38 PM »
That explains a lot....! Thank you!!
And why does not stop the movement at the indicated measure and say "Probe not find" or something? Can be the same issue?

Regards

4
General Mach Discussion / Problem with auto Zero tool
« on: September 17, 2018, 02:44:29 PM »
Hello!!

Im trying to setup the auto zero tool script. Initialy without the CNC (is in the shop). I have setup a key map to probe signal and run the script. Nothing happends when I press the key but also the Z movement never stops.
If I run the command G90 G31 Z-5 F100 to try out (in mm), the Z movement goes down forever (previously I run the code G21 just in case).

What can be wrong?

Thanks!!!

Pages: 1