Hello Guest it is May 26, 2019, 01:38:12 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - N00B

Pages: 1
1
Hi, N00B here. Always a N00B whether it be 4x4-ing or CNC-ing - you can never learn enough. Well, I can't. ;)

This is my second post. So yeah, this is me. Built me a CNC from scratch. Using it to build me a bigger CNC - y'all know the story I'm sure!

That's it from me for now...

2
General Mach Discussion / Re: Please Wait...Generating Path
« on: September 02, 2018, 05:08:11 PM »
So I am reviving this thread, as I had this exact problem. (1st official post, BTW!).

Initially I thought that it was the 84,000 lines of g-code that broke Mach 3, as it didn't want to generate the tool path when I loaded the g-code. Then I decided to actually connect the breakout board to my PC running Mac 3, and voila, it worked!

So in my case, the fix for this was to connect the breakout board to my Mach 3 PC. ;)

Pages: 1