Hello Guest it is March 28, 2024, 04:41:49 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - olylyly

Pages: 1
1
General Mach Discussion / Question on Z axis
« on: August 30, 2018, 09:32:10 PM »
Hi, I'm mewbie, Just new to the mach3 software, my problem is when in the middle of a program and want to go back to zero the Z axis drags across the work piece. My question is? Is there a way of putting the Z axis into a safe mode or homing first before X & Y axis move.

Thanks

Pages: 1