Hello Guest it is March 28, 2024, 05:28:41 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - JCBOND

Pages: 1
1
General Mach Discussion / Re: Mach3 and LazyCam Pro
« on: July 27, 2007, 11:58:33 PM »
Hi there......  I  get lazy cam pro licence  yestarday , there is now under mach3 folder how can I  upgrade it .  I    want to cut a piece of tile  18"x18" ,  I create my desing on my  AUTO CAD,  and then open LAZY CAM to cut some circles at .5" deep and I made some spiral figures where i need to cut at .1875" deep after the circles  i try  diferent ways but when i setup  deep  set alll layers....... how can i set diferent deeps?

Pages: 1