Hello Guest it is July 27, 2021, 04:55:50 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - lavon

Pages: 1
1
General Mach Discussion / set z-zero
« on: December 30, 2018, 11:07:12 PM »
in Aspire I set zero to bottom left corner of mat'l . I have only used the auto touch plate to set the start at TOP left corner. please tell me how to set Mach3 to bottom of mat'l to start.

can't find answer in forum or FAQ.
Thanks


2
"by virtue of posting (where?) in this thread you ill get an email every time someone posts in it"
thanks for the reply BUT, my question is:
I see no place anywhere on the pages in the forum for me to START a post.
I see Search, help, etc.

AGAIN:
there is NO post a message box to 'click' anywhere on my pages to post an ORIGINAL post
I have read in the help section where it's supposed to be but
not anywhere on any topic page.
thanks

3
there is NO post a message anywhere on my pages.
I have read in the help section where it's supposed to be
not anywhere on any topic page.
I can obviously reply
this is my reply to a post.
WHERE DI I POST A NEW ONE???

email sent to me:
 reply has been posted to a topic you are watching by difrancocontractorsinc.
AND WHERE IS THIS POST

4
there is NO post message anywhere on my pages.
I have read in the help section where it's supposed to be
not anywhere on any topic page.
I can obviously reply

5
General Mach Discussion / Re: Mach3 Pendant
« on: September 03, 2018, 03:04:29 PM »
Centroid Wireless MPG for Acorn CNC Control System CWP-4

Will this pendant Work with Mach3?

6
General Mach Discussion / ink fill
« on: August 27, 2018, 07:09:59 PM »
looking for tool to ink fill engraving. like this but maybe more capacity

7
General Mach Discussion / Re: very newbie
« on: August 26, 2018, 09:47:32 PM »
been there done that
again,All Mach3 terms are greek to me.

8
General Mach Discussion / Re: very newbie
« on: August 26, 2018, 09:29:33 PM »
the phone support is very slow and I end up w/the "not as knowledge" person not 2nd tier support
thanks for the reply
anyone who knows anyone near to help

9
General Mach Discussion / very newbie
« on: August 26, 2018, 08:24:23 PM »
Brand new to mach3.  I live south of Reno (Gardnerville) All Mach3 terms are greek to me.
I have CNC Router Parts machine
I have not got very far looking at posts all over the internet.
I need in person instructions. Will pay for same
Anyone near to me? 
Thanks, Lavon. 775 392-1398.  wisemanlavon@gmail.com

Pages: 1