Hello Guest it is March 28, 2024, 11:01:10 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - onin66

Pages: 1
1
Hi, I'm Nino
I'm from Spain.
I have no idea of cnc, cam, dnc, ... stepper motors, servo motors, drivers ...
But in the last two months or so I have begun to learn a little because I need a cnc table for plasma cutting and can not afford for a commercial one.
I was almost in despair till yesterday that I found this site and mach3, I think I can do it now.
By now I can help very little but i'll try to help all I can.

When I remember the days when i made my own press brake (3000 mm wide, 100 Tons) five years ago, and didn't even think of a cnc because it seemed to me it was
some kind of  STAR WARS devie ... ;D.

I'm not an engeneer, nor electronic, I'm just a self employed welder, but I like machinery and if  I can make a machine myself ... 

Now my next challenge is the cnc table. I have a lot to learn and maybe its out of my limits but I hope to be able to do it with all the help that can be breathed in this site.

Thanks to all in advance.

Regards.

2
Forum suggestions and report forum problems. / logged as other user
« on: July 27, 2007, 09:46:47 AM »
Hi.
This is my first post. I want to greet everybody.

I think I will learn a lot from all of you and hope I can help sometime.

And now I'll go to the point:
I discover this forum yesterday, I think it's really great. I'm trying to make a cnc table for my plasma and think this is the right place.  :)

The "problem" is that yesterday I entered the spanish forum and to my surprise I saw myself  logged as GPDC  :o and I had not registered yet.
I think it can be some kind of failure in the system.  ???

So I notice it to you for you can solve the problem.

Maybe this is not the right way but I don't know other way (I'm a complete good for nothing in theese matters)

Anyway I'll try to contact any administrator when I know about any (I'm so excited about the chance of had found a site that can help me that I don't want
anyone to think I'm using the identity of any member in this forum so perhaps I'm trying to apologize too soon and in the wrong way)

Hope noone is annoyed with me.

Best regards.

Pages: 1