Messages

1

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 20, 2020, 07:33:23 PM »

Hi Graham I can send you the whole mach3 folder privately which would make it far easier to investigate if you like? regards Stuart

2

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 20, 2020, 07:31:17 AM »

Can anyone help me with this problem? All help appreciated regards Stuart

3

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 19, 2020, 08:43:02 AM »

Is this the .set file you mean?

4

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 19, 2020, 08:26:09 AM »

I have attached I had to change the name as it would not let me upload it as start.M1s file regards Stuart

5

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 19, 2020, 08:11:24 AM »

I am running Mach3 only. regards Stuart

6

General Mach Discussion / Re: PDB issue Mach 3 ATC

« on: June 19, 2020, 07:35:50 AM »

This is thr M6Start file if needed, I have been trying for many hours to work this out and am lost. regards Stuart

7

General Mach Discussion / PDB issue Mach 3 ATC

« on: June 19, 2020, 07:29:31 AM »

Hi there I have attached 1 Macros, newbie here I am trying to work out why the pdb wont close and gives me the error pdb failed (tool not secure). when it actually has opened and closed correctly.All help appreciated. Stuart

8

General Mach Discussion / Re: Pocket Cut Issue.

« on: June 18, 2020, 04:54:44 AM »

Hi there I am a newbie to all this I have uploaded the xml file and the gcode. Is there any way to see if the issue is in here? all help appreciated. regards Stuart

9

General Mach Discussion / Re: Pocket Cut Issue.

« on: June 16, 2020, 03:52:05 AM »

I think it may be in the atc gcode, as I did a clean install without the atc and no issue. regards Stuart

10

General Mach Discussion / Re: Pocket Cut Issue.

« on: June 15, 2020, 07:25:13 AM »

No I am not this code is written in vetric aspire.
 I am a newbie where the code is concerned Regards Stuart