Messages

1

General Mach Discussion / What SSR relay used to router on/off using onboard spindle on/off terminal

« on: August 08, 2018, 07:56:35 AM »

I need setup using router on/off on board connection Pin 17 for spindle on/off . I used SSR relay wiring from Pin 17 I can't get router on/off while running gcode. all pins have assign but no results.
while sending M3 and M5 MDI screen Breakoutboard LEDs on/off router can't starting. What I am missing any help will greatly appreciate.

Thanks

2

General Mach Discussion / Re: Mach3 did not start router spindle automatic using SSR relay

« on: August 07, 2018, 01:19:40 PM »

I am newest for all of this can explain me more. how to assign M codes. also I seen LED on in breakout board when I use M3 and off when M5. F5 key just board LEDs on/off not spindle.
Thanks

3

General Mach Discussion / Mach3 did not start router spindle automatic using SSR relay

« on: August 07, 2018, 12:53:15 PM »

I've been trying to get Mach3 to stop/start my router through a BOB connected through pin 17 to a SSR. I have the spindle relays activated and output 1 set to the proper port and pin.  I can get it to toggle on and off with the F5 key and with the spindle button.  When I try to run G Code command M3S20000 or M5 nothing happens. I have also tried to enter M3 and M5 in the diagnostic screen with no results.
Any help will be greatly appreciated. Thanks