Hello Guest it is March 29, 2024, 07:44:23 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - AFigula

Pages: 1
1
General Mach Discussion / Re: Z axis going deeper and deeper
« on: July 30, 2018, 12:43:55 PM »
Hi all, I had the same problem years back Z ramping up...cutting air. I found it happened during very warm days, this may sound weird but I fixed the ramping up by putting a fan directly blowing on my G540 "Go Figure".


Al 

Pages: 1