Hello Guest it is April 28, 2024, 05:24:02 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - reset131

Pages: 1
1
General Mach Discussion / digitizing
« on: June 26, 2006, 10:29:12 PM »
How do I get data into Rhino3  from Mach2 or Mach3 when using the digitizing wizard?  It appears that the data goes to a txt file.  Any suggestions regarding translation into a Rhino compatable format?
thanks ken

Pages: 1