Hello Guest it is January 22, 2022, 04:23:18 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dannyb

Pages: 1
1
General Mach Discussion / Re: Very Slow Feed Rate
« on: November 12, 2020, 10:24:20 AM »
I'm having the same problem, mach was working till I reloaded it and must have changed something. Works fine in jog, but 1" on DRO is about 12" on mach. Not sure what a MDI input is

Pages: 1