Hello Guest it is April 25, 2024, 11:09:27 AM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - dwallzee

Pages: 1
1
General Mach Discussion / Re: NEWBIE MACH3 LATHE PROBLEMS
« on: June 25, 2018, 03:55:14 PM »
that worked. thank you so much

2
General Mach Discussion / NEWBIE MACH3 LATHE PROBLEMS
« on: June 25, 2018, 02:09:42 PM »
I just purchased a shopmaster cnc mill lathe combo. After initial setup mach 3 mill works perfect. I'm able to control all axis's. When I switch to Mach3 lathe I am immediately met by estop requested. I click reset and it will not leave the mode. Any help would be appreciated. Thanks.

Pages: 1