Hello Guest it is March 29, 2024, 10:39:51 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - N_Arnold

Pages: 1
1
Mach3 under Vista / Re: Need Direction for what to try next.
« on: June 21, 2018, 05:33:47 PM »
Bryannab,

I could not find update  KB284826, but I could find update  KB4284826.
After removing and restarting my computer Mach3 will startup.  I have not got to the parallel port yet, but I will keep ya all posted.

Thanks Guys
Nick


2
Mach3 under Vista / Re: Need Direction for what to try next.
« on: June 21, 2018, 01:46:51 PM »
I will try that tonight and post back the results!

Thanks

3
Mach3 under Vista / Need Direction for what to try next.
« on: June 21, 2018, 12:45:26 PM »
Hello
I  recently upgraded my PC.  My old PC was just too old and slow.  I don't have all the hardware specs handy at the moment, but I would like to get a few questions out there.

So I am running windows 7 32 bit with sp1 installed. 
The processor is an I5 seventh generation.
Parallel Port is a PCI card.

When I installed mach 3 and fired it up on the PC, it immediately crashed and rebooted.  I tried a couple more times and had the same result.
I read about 2 windows 7 updates that could cause this, neither one are installed on my computer. I'm not sure where to go from here.

Will mach 3 work with a pci parallel port?
Will mach 4 work with a pci parallel port using Darwin and windows 7?
Any other Ideas why windows 7 is crashing when firing up mach 3?

I will continue digging but was hoping maybe you guys could get me on the right path.

Thanks
Nick


Pages: 1