Hello Guest it is March 28, 2024, 07:17:47 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Ted Kelley

Pages: 1
1
General Mach Discussion / Re: Help needed
« on: June 07, 2018, 10:43:41 AM »
Thanks everyone.  reloading the UV100 software was whit I needed.  All is well.

2
General Mach Discussion / Help needed
« on: June 06, 2018, 05:10:06 PM »
Hi my name is Ted Kelley and I am a newbie.

I got ahold of a pirated copy of Mach 3, and had a very hard time getting rid of it.  I would uninstall it and load a "good" copy off Artsoft's website and the leftovers from the pirated program would corrupt the new copy.
My son came over last night and worked his magic and cleaned a the bad leftovers off you machine.  I downloaded Mach 3 again from Artsoft and it came in clean.  I have bought the license and now it is licensed to me.
I and using a UC100 CNC Motion Controller.  When I installed the Mach 3 program I deselected the Parallel port driver. I had red somewhere that is did not need it when using the UC100 CNC Motion Controller.
Did I mess up?  I do not get a blue light on the UC100 and now the motors do not move.  All of that was working with the pirated program.
When I look at the USB ports in device manager is says that the device is work correctly.   Help

3
Hi my name is Ted Kelley and I am a newbie.

I got ahold of a pirated copy of Mach 3, and had a very hard time getting rid of it.  I would uninstall it and load a "good" copy off Artsoft's website and the leftovers from the pirated program would corrupt the new copy.
My son came over last night and worked his magic and cleaned a the bad leftovers off you machine.  I downloaded Mach 3 again from Artsoft and it came in clean.  I have bought the license and now it is licensed to me.
I and using a UC100 CNC Motion Controller.  When I installed the Mach 3 program I deselected the Parallel port driver. I had red somewhere that is did not need it when using the UC100 CNC Motion Controller.
Did I mess up?  I do not get a blue light on the UC100 and now the motors do not move.  All of that was working with the pirated program.
When I look at the USB ports in device manager is says that the device is work correctly.   Help

Pages: 1