3
« on: May 31, 2018, 08:52:58 AM »
Auto tool zero doesn’t stop on probe signal change
I tried few different scripts for Z auto tool zero, but the Z axis doesn’t recognise the Digitize contact and doesn’t retract, but continues to run
My set up is:
Galil DMC-21x3
Mach 3: R3.043.066
In ports & pins: Port is Enabled (#1) with Pin 30. When the plate is touched, the Digitiser changes status to Green LED.
I tried changing the Pin from 30 to 8 which was High (Green LED) and the script displayed an error message and refused to move the Z suggesting that something somewhere may be working
Any advise will be appreaciated, thanks