Hello Guest it is November 29, 2020, 06:01:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - stefanos

Pages: 1
thank you very much , the problem is from toolpath, now works fine. :D

G-Code, CAD, and CAM discussions / large g-code problem on mach3
« on: May 31, 2018, 07:02:28 AM »
hello .I have problem with mach3 when load large g-code 900.000 lines. Mach3 is begin slow and when i move axis loosing a lot of steps and stuck, in other smaller g-code files runs without problem , i use a full version on mach3 and i have pc windows7 with intel pentium4 3ghz , memory 3ghz  and graphic card  amd radeon r7 1ghz memory. How to solve the problem? (sorry for bad english) :)

Pages: 1