Hello Guest it is March 29, 2024, 10:32:34 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - isaiah

Pages: 1
1
is the expert version available to buy would be interested to try it out if it has a trial anyway

2
Expert is a new version they say might work its not on their web yet got a reply from tech support this aft I might be best off using 2 separate controls

3
they'd each have there own work offset ....... we might try with 2 controls and loop an output from control A to B and from B to A so one waits on the other exec.  Or use Expert version .... we would use Galil to control servos

4
we need to control 2 milling heads each has 3 axis they need to run simultaneously on the same part we might be best off to use 2 controllers maybe

5
Hi can someone give me some insight on if its possible to customize Mach4 to run 2 sets of G code simultaneously then output stop signal after completion 

Pages: 1