Hello Guest it is December 07, 2019, 02:30:05 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - engineering

Pages: 1
1
General Mach Discussion / Re: KX1 spindle direction problem
« on: March 10, 2019, 10:07:08 PM »
about M03&M04 i know it. But the problems now is the spindle still rotate to CCW when i input M03. I think its not issue about wiring or motor problems.

2
General Mach Discussion / Re: KX1 spindle direction problem
« on: March 08, 2019, 08:09:15 PM »
how can i get a kx1 profile, before this I using the profile my machine work normally.

3
General Mach Discussion / Re: KX1 spindle direction problem
« on: March 06, 2019, 08:55:49 PM »
Nothing issue about wiring. The problem is about a software. How can i get about KX1 profile for my machine or parameter about kx1

4
General Mach Discussion / Re: KX1 spindle direction problem
« on: March 06, 2019, 08:48:29 PM »
single phase

5
General Mach Discussion / Re: KX1 spindle direction problem
« on: March 06, 2019, 08:39:43 PM »
before this the machine work normally, we did not disturb the electrical wiring. Suddenly, the spindle motor run CCW. So how ? i don't think it is because my wirig, any idea?

6
General Mach Discussion / KX1 spindle direction problem
« on: March 05, 2019, 10:01:13 PM »
Hello,
I wan to ask about my cnc mach3 KX1 have a problem about a spindle direction, my spindle direction only CCW, change the code to m3 still same direction. Is it because my kx1 profile have a problem?

Pages: 1