Hello Guest it is May 10, 2021, 01:58:20 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Briar Patch

Pages: 1
1
Mach4 General Discussion / Re: Setting up Mach4
« on: March 29, 2018, 04:29:20 PM »
Craig, Thank you for the information.  Delete the profile and start again?  How do I find the profile?  I wasn't able to find it with some searching on my own.  Also, where are the standard profiles found, that I can copy?  Again, I appreciate the help as I get started with this machine.
Tommy

2
Mach4 General Discussion / Setting up Mach4
« on: March 28, 2018, 09:12:39 PM »
Hello- I am new to the art of CNC work, and I'm trying to get my CNC unit set up to make it's initial run.  In the process of downloading and beginning to use the software, I think I have entered incorrect information into the 'Create Profile' pop-up.  I can't seem to figure out how to edit that information.  Can someone point me in the right direction?
I'm sure I'll have more questions in the near future, but for now, I don't yet know what I don't know!
Thanks.
Tommy

Pages: 1