Guest
Show Posts
1
General Mach Discussion / laser/impact engraver
« on: July 17, 2007, 11:26:56 PM »
Thanks in advance. I'm getting an output on the digital trigger (port 1
pin 14) when I have the laser trigger turned on and the grid set to any
value (x=n) (y=n). When I load the plugin it runs just like it should, but when it
starts the scan I don't get any output pulses on my scope without the
laser trigger turned on. Then the pulse train only follows the values
that are entered into the grid parameters not the greyscale image.
What am i missing? I would like to use my laser (TTL trigger) with M3
Thanks so much for everything.
Ross Martin
pin 14) when I have the laser trigger turned on and the grid set to any
value (x=n) (y=n). When I load the plugin it runs just like it should, but when it
starts the scan I don't get any output pulses on my scope without the
laser trigger turned on. Then the pulse train only follows the values
that are entered into the grid parameters not the greyscale image.
What am i missing? I would like to use my laser (TTL trigger) with M3
Thanks so much for everything.
Ross Martin