Hello Guest it is August 15, 2020, 01:57:37 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Greg F.

Pages: 1 2 3 4 »
1
Mach4 General Discussion / Re: Steps per unit wizard
« on: April 25, 2019, 11:13:03 AM »
When I press ok I get this message
Lua:Syntax error during  pre-compilation

2
Mach4 General Discussion / Re: Steps per unit wizard
« on: April 25, 2019, 08:59:44 AM »
Yes ..but is not working right now

3
Mach4 General Discussion / Re: Steps per unit wizard
« on: April 25, 2019, 07:16:12 AM »
I'm using MB2 Bob with ESS...
If you have mach4 look at that wizard
Button ...

4
Mach4 General Discussion / Steps per unit wizard
« on: April 24, 2019, 09:01:11 PM »
I try to use the steps per unit wizard
And is not working or maybe I'm doing
Something wrong...I'm using 4.2.0.4162...

5
Mach4 General Discussion / Re: Mm back to inches
« on: April 08, 2019, 07:43:00 PM »
Ok thanks..for your help

6
Mach4 General Discussion / Mm back to inches
« on: April 08, 2019, 06:55:09 PM »
Like to know if I'm in mm in mach4 and I want to make it inches do I have to recalibrate...

7
Oh ok thanks ..I'll try it again..

8
The G91 Z-××.x") --xx.x=
Is the x spouse to mean something...

9
Ok I'll try that..thanks

10
I will take a look at DTZ videos..hoping I can get it right...

Pages: 1 2 3 4 »