Hello Guest it is March 28, 2024, 07:06:01 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - tupper

Pages: 1
1
General Mach Discussion / Re: JNC 40M Ver. 1.49 driver
« on: March 10, 2018, 08:55:13 AM »
Thanks

2
General Mach Discussion / Re: JNC 40M Ver. 1.49 driver
« on: March 10, 2018, 07:25:30 AM »
thanks but I have 1.45 and 1.58 and they don't work, I think I am going to replace the board with something that has some sort of tec support when there is a problem. Any suggestions , needs to work with a 64bit windows system.

3
Hi, My name is Tim Mahaffey and I am new to this forum or any forum. I have been doing CNC woodworking as a hobby for about 5 years now. I have a 9x5 machine that runs on Mach3. I have a background in electronics and worked in research and development for Tupperware mnfg. for about 15 years. I was wondering if anyone knows where I can find drivers for the Jamen JNC 40m version 1.49 or can anyone recommend a good usb or Ethernet control board. The biggest drawback I see to owning a CNC is you very quickly see relatives and friends that you have not seen in awhile and it usually takes about 5 minutes for them to suggest that they would like something built. Hope everyone is well and have a nice day.
Tim
P.S. If anyone is in the Conway/Myrtle Beach area, drop me a line.  mahaffeytim@gmail.com

4
General Mach Discussion / JNC 40M Ver. 1.49 driver
« on: March 09, 2018, 10:09:30 AM »
Can anyone please tell me where I can find driver downloads for the JNC 40M boards. I have searched all over and cannot find anything. If you wish you can contact me directly at mahaffeytim@gmail.com.

Pages: 1