Messages

1

PoKeys / Re: PoKeys homing limit switch issues

« on: March 14, 2018, 05:52:03 PM »

i still have not been able to get  the axis to back off switch

2

PoKeys / Re: PoKeys homing limit switch issues

« on: March 05, 2018, 04:30:02 PM »

i set all axis at 2000 no the motor does not back off

3

PoKeys / Re: PoKeys homing limit switch issues

« on: March 05, 2018, 02:46:15 PM »

X-p13 L++  13-- Ac low , shared with limit     Y- p 11 L++ 11-- act low ,shared with limit   Z-p15 L++  15-- act low  ,Shared with limit  A-Slaved to y  P 13++   L-- 12 act low, shared with limit

4

PoKeys / Re: PoKeys homing limit switch issues

« on: March 05, 2018, 10:38:43 AM »

i updated firmware ,the pulse setting is at 2000  until i can get it to work then i will fine tune settings .It still goes to z switch and stops  with open switch signal on motor 3 Note all of setting i put in mach and plugin show up in the pulse engine app.

5

General Mach Discussion / Re: Will not zero machine coordinates

« on: March 05, 2018, 08:11:47 AM »

i reset the units on z .  It would not except to step number before, I since then replaced  the driver now  now it will except the step no.  The ref all still only goes to switch and stops on limit does not back off

6

General Mach Discussion / Re: Will not zero machine coordinates

« on: March 04, 2018, 01:19:17 PM »

setting up new table all is well' except when I hit ref all z axis goes up to switch and trips switch stops  off set set at 1"  Note on setup i set my unit to imperial ["] x&y are set in inch, z setup in metric is this normal

7

PoKeys / Re: PoKeys homing limit switch issues

« on: March 03, 2018, 11:14:33 AM »

i entered as stated when z axis hits switch it stops  i have to reset and move axis manually

8

PoKeys / Re: PoKeys homing limit switch issues

« on: March 02, 2018, 08:11:21 PM »

i am attempting to setup mach3 with poyeys 57cncdb25 trying to set up limit switch back off. and soft limits and slow down.  i set up in the application tab with no success  what do i set up in the app there is a lot of info duplicated . what is necessary what is not needed  

9

Mach4 General Discussion / Re: New people welcome !! Come in here and introduce your self!

« on: March 01, 2018, 07:19:27 PM »

Hi my name is Owen  I am converting a plasma table to router table, but did not get computer with it.  So I could not find a parallel computers so went with win .10 and mach3.  But i am having trouble getting ref all working. I am using a pokey 57cncdb25  controler