Hello Guest it is March 28, 2024, 11:36:56 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - idrathergofishing

Pages: 1
1
General Mach Discussion / Re: Tool Change
« on: March 26, 2018, 03:31:28 PM »
Did it work for you?

2
General Mach Discussion / Re: How to setup port and pins and stuff.
« on: March 18, 2018, 03:26:18 PM »
GRBL 0.9J,USB port cnc engraving machine control board, 3 axis control

Connection: USB (USB-CH340)

Software: GRBL controller, UniversalGcodeSender

Input voltage: 12-36V

Master chip: atmel 328P (arduino nano)

Stepper motor driver: A4988

Spindle drive chip: MOSFET (recommendation 12~36V, current : within 10A )

Spindle PWM speed: Support

Support stepper motor: 12V, maximum current of 2A or less is recommended within 1.5A and additional heat. (Any stepper motor 42, 57)

Laser engraving: Support

Power Interface: 5.5-2.5mm DC interface

3
General Mach Discussion / Re: Tool Change
« on: March 18, 2018, 01:14:31 PM »
-
N1000 M06 D04 T04  (change to 4 mm in D04)
N1010 S3000 F3000
-
How do I make the spindle return more quickly ?

add a G00 plus whatever plane move

N999 G00 X__ Y__ Z__
N1000 M06 D04 T04  (change to 4 mm in D04)
N1010 S3000 F3000

4
General Mach Discussion / Re: How to setup port and pins and stuff.
« on: February 28, 2018, 06:18:56 PM »
Hi,
what sort of controller? I don't think I've ever seen anything quite like that.

Need to know:
1) What PC and OS?
2) What controller (parallel port or otherwise)?
3) What stepper drivers?

Craig

HP Pavilion TS 15 notebook, Windows 10 x64
USB?
no clue?

5
When asking questions be sure to post in the proper area.
Welcome aboard!
Mike

That wasn't a question. It's the reason why I'm here.

6
Hi. taking a CNC class bought a cnc router wanted more features than what grbl control had so i got mach3 and now trying to figure how to make it work.

Pages: 1