1
Mach4 General Discussion / Re: mcCntrlGcodeExecuteWait fail
« on: April 09, 2018, 10:14:49 PM »
Try adding an actual \n at the end of each line
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi,
may I suggest measuring the elapsed time for a linear move and compare with what you expected.
One possiblilty is that Mach4 is going to fast or another is that Mach3 had been going to slow. Accurate measurement
will be the only way to sort out which.
Craig
Thanks Russ for the link to warp9 .
Looks like the Ethernet version is Mach 4 only and supports backlash.
Craig thanks for the info! Will check out Hicon and ESS
Lots to research here!
Hi,
have you actually measured/timed it so you know exactly what speed its doing?
Craig