Hello Guest it is March 29, 2024, 06:06:13 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - Jack1944

Pages: 1
1
General Mach Discussion / Stepper will not move
« on: January 17, 2018, 11:08:41 AM »
New to this forum so bear with me please. Using the trial version of Mach 3 I am unable to activate my Nema 23 stepper motor. My setup may be the problem.

I want to run Mach 3 from my laptop via USB. My set up is as follows:

1. USB from laptop to interface board ( Mach3 Interface Board CNC 5 axis with Optocoupler Adapter Stepper Motor.)
2. Interface board to TB6560 controller/ driver board via DB25.
3. Power from 24V, 15A power supply to TB6560 board.
4. Nema 23 stepper connected to my “X” axis connector.

All led’s are on. I think that means everything is working?
Loaded sample G-Code into Mach3 and hit “ Cycle Start” and nothing happens.
I have setup Mach 3 per tutorial.
Suggestions welcome.

Thanks in advance
Jack


Pages: 1