1
FAQs / Re: new to this and getting nothing
« on: January 03, 2018, 09:12:11 AM »Quote
Quoteplayed around with a few things trying to get my head around it and yay! movement!
Any idea what it was that you did ?
Tweakie.
I opened mach 3 turn, loaded file ball.tap and then ran the cycle. worked perfectly apart from the file wasn't for a lathe and the cnc's not a lathe! followed the red green and purple lines started and stopped automaticly. But in mach3 nothing?
attached are the photos, have more if needed
many thank you's tweekie