Hello Guest it is September 18, 2020, 11:03:57 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - capdenny

Pages: 1
General Mach Discussion / Re: Homing Switches
« on: March 21, 2020, 08:54:20 PM »
I am using micro switches and the z axis dose move off the switch ut mach still keeps moving the machine dose not keep moving

General Mach Discussion / Homing Switches
« on: March 21, 2020, 07:34:05 PM »
When I ref all home the z axis makes the switch and comes off the switch and stops but in mach3 it stills show the z axis is still moving. so it will not ref home any further than the z axis. Has anybody had this problem and if so what did you do to correct it.

General Mach Discussion / Mach 3
« on: March 14, 2019, 03:59:58 AM »
The problem I have is when running a program my cnc will not run faster than 58 ipm, even if I manually increase the feed rate. So is there something in mach 3 that puts a limit on how fast your feed rate is? If so how do I change the limit?

Thank You
Dennis Killian AKA capdenny

General Mach Discussion / Re: Probing
« on: March 18, 2018, 03:36:40 PM »
 Try This Link  https://item.taobao.com/item.htm?id=41502492918

General Mach Discussion / Re: Probing
« on: March 18, 2018, 03:33:12 PM »

General Mach Discussion / Probing
« on: March 17, 2018, 11:23:16 PM »

I am a newbie and I am trying to set up a 3 axis probe. I am using a Bit Sensor breakout board. I can not get the probe work. I have tried using all the inputs and all the pins but still nothing. I can not get a picture of the board, but I do have a link that shows the board ( https://gd3.alicdn.com/imgextra/i2/1/TB1gZBOGp*********XX8Xp***************************X_!!1-item_pic.gif_400x400.jpg ).
If you could can you tell me the settings in mach3 and where on the board I connect.

Thank You,
Dennis Killian

Pages: 1