Hello Guest it is August 08, 2020, 11:19:12 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - wildgrav

Pages: 1 2 3 4 »
1
CVI MachStdMill (MSM) / Re: Spindle Speed MSM
« on: August 05, 2010, 07:10:03 PM »
Thanks Dave

Every thing you noted was correct. Even went back to scratch with the spindle problem to see if I missed some thing with a fresh head and couldn't win that battle. All seems to work well with proceedures you suggested. Version R3.043.012 is what MSM should be operating with yea?

Noel

2
CVI MachStdMill (MSM) / Re: Spindle Speed MSM
« on: August 05, 2010, 06:10:26 AM »
Hi Dave

Started the old version and then loaded MSM screen set as you suggested from within the old version and all works as it should. Two of us checked the setup in case I was loosing my brain and agreed that the grey mater as good for a few years yet . However just doing what I did would prove that I missed something??? Wouldn't it??

Regards

Noel

3
CVI MachStdMill (MSM) / Spindle Speed MSM
« on: August 04, 2010, 03:22:52 AM »
Hi All

For the life of me I cannot get the spindle going in MSM. Coppied all the pins from previousl version and that still works as well. Any clues

Noel

4
So you have dumped the XML off the desktop to the laptop....yea?

Noel

5
Your are not alone as my spindle starts if I stop and start again. Sometimes it starts first go. Using latest version.

Noel

6
General Mach Discussion / Re: Combined Lathe / Mill in MACH3?
« on: March 16, 2010, 10:50:33 PM »
I put a vartical mill attachment on my lathe and tht way you don't have to change anything. I havn't hooked up the Y axis yet ut the Gecko are ready to go. http://www.youtube.com/watch?v=_X2RVwgg88M

Regards

Noel

7
General Mach Discussion / Re: Rapids in Lathe Blue Screen Set
« on: January 31, 2010, 05:22:41 AM »
Thanks Hood

Screen 4 did the job. Not hard at all for that little job

Regards

Noel

8
General Mach Discussion / Re: Rapids in Lathe Blue Screen Set
« on: January 30, 2010, 10:21:25 PM »
Silly Me

The Font is too big for the window. gos to 999 so you cannot see 1000 in the DRO.

How do you edit that?

Noel

9
General Mach Discussion / Rapids in Lathe Blue Screen Set
« on: January 30, 2010, 07:18:52 PM »
Morning All

I have a lathe with a vertical mill on it and I have written some GCode for the moves and all goes very well except for my rapids which won't go past 600mm a minute although you can get 2m a min manually.

Anybody got any clues?

Regards

Noel

10
General Mach Discussion / Re: Version R3.042.035 No Go
« on: January 24, 2010, 01:50:25 AM »
Yep All good. Fixed it on the mill and the lathe.

Regards

Noel

Pages: 1 2 3 4 »