1
General Mach Discussion / Re: Fusion 360 & Mach3 Mill G-code and Post processors
« on: December 26, 2017, 10:21:12 PM »
Ok tried it and it's doing funky things using the mach3/mill post processor.
I machine zero everything.. Bring my tool to the corner of the work area zero out x, y and z.
Load the g code,.. Click run.. It's goes to home zero like it wants to run program but again freezes.. It's like it's binding or stuck.. When it's really not.. Is there anyone that could show me a walk thru to confirm my post processor is setup correctly with my Mach 3 setup I currently have. I'm thinking it's something very simple as it did my spoilboard effortlessly.
I did disable coolant in tool library.
I machine zero everything.. Bring my tool to the corner of the work area zero out x, y and z.
Load the g code,.. Click run.. It's goes to home zero like it wants to run program but again freezes.. It's like it's binding or stuck.. When it's really not.. Is there anyone that could show me a walk thru to confirm my post processor is setup correctly with my Mach 3 setup I currently have. I'm thinking it's something very simple as it did my spoilboard effortlessly.
I did disable coolant in tool library.