Guest
Show Posts
1
General Mach Discussion / Not connection (Breakout board te421+TB6600+NEMA23) with my computer
« on: December 16, 2017, 12:27:52 PM »
Hello,
I'm new on this forum, so I do not know if I'm writing under the right section.
I have problems with NEMA23 motors and connection with my computer. I wonder if anyone knows, if this connection is correct? why it does not work? It shows connection on the computer, but i don't know if it's right. On the computer it shows that there is connection, but i don't know if i must change anything
thank you very much for the answer
I'm new on this forum, so I do not know if I'm writing under the right section.
I have problems with NEMA23 motors and connection with my computer. I wonder if anyone knows, if this connection is correct? why it does not work? It shows connection on the computer, but i don't know if it's right. On the computer it shows that there is connection, but i don't know if i must change anything
thank you very much for the answer