Hello Guest it is March 28, 2024, 08:06:33 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - aju

Pages: 1
1
VB and the development of wizards / Re: Emco Turn tool changer macro
« on: February 12, 2018, 06:17:50 PM »
For those interested, I have just completed the electronics to use the original emco tool changer board and a MACH3/MACH4 compatible BOB (ESS/MB2 - from www.cncroom.com).  Attached is a layman's schematic diagram showing you what you need to and how it all works.  This diagram also shows you an example relay which I sourced locally in Australia from www.oceancontrols.com.au.  Im sure you can find something suitable locally in your part of the world.   You can then use the macro given in these posts for MACH3 or modify it for MACH4.  You may want to add an additional OUTPUT to the macro to turn the ATC on/off.  The schematic has 2 outputs (OUTPUT1 - on/off and  OUTPUT2 - FWD/REV) with a diagram of the relay connections.

Pages: 1