1
General Mach Discussion / Mach Not loading G Code?
« on: December 13, 2017, 08:56:08 PM »
Hello Folk...
New to forum. And serious new guy question here. (I did search for a good time before asking this)
My G Code is not loading into Mach. This is a new development. Been following the original procedures for almost 3 years. Lots of code run thru my machine.
It appears to load up a default set of parameters but nothing looking like anything I have seen before.
I thought it was my latest program. So I did some trouble shooting and loaded an older file that I have used many times a month. Same result.
Any thought would be super appreciated....
Attached photo of the text loaded into the code box.
New to forum. And serious new guy question here. (I did search for a good time before asking this)
My G Code is not loading into Mach. This is a new development. Been following the original procedures for almost 3 years. Lots of code run thru my machine.
It appears to load up a default set of parameters but nothing looking like anything I have seen before.
I thought it was my latest program. So I did some trouble shooting and loaded an older file that I have used many times a month. Same result.
Any thought would be super appreciated....
Attached photo of the text loaded into the code box.