Messages

1

General Mach Discussion / Re: Preset position

« on: November 09, 2017, 10:39:29 AM »

ok thanks.  Will do and report back

2

General Mach Discussion / Preset position

« on: November 09, 2017, 09:40:09 AM »

I use Mach3 on a JoesCNC router table.  Home is front left and that's where I position the head to get started for most cuts, but the whole gantry is in the way for loading material, so i usually end up sending it all the way back and right for loading.  I program it in the g-code of the cut files to move the head there but is there such a thing as a programmable key on the keyboard to send the head somehere?  Maybe a "run G-code" key preset?
thanks
JF