1
Mach4 General Discussion / Mach 4 THC
« on: May 24, 2018, 02:16:38 AM »
Hi Everyone
I have a proma THC and it works really well under mach3, however I want to use mach4 due to the fact that it is maintained. Also this Windows upgrade issue.
I have the leds showing that the THC is sending the signal through the UC100. The UC100 diag is showing the signal, so why is the Z axis not moving?
Any help would be great.
Many thanks
R
I have a proma THC and it works really well under mach3, however I want to use mach4 due to the fact that it is maintained. Also this Windows upgrade issue.
I have the leds showing that the THC is sending the signal through the UC100. The UC100 diag is showing the signal, so why is the Z axis not moving?
Any help would be great.
Many thanks
R