Hello Guest it is March 28, 2024, 04:03:19 PM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - eyeten@yahoo.com

Pages: 1
1
One on one phone support. / Re: CAN NOT PROGRAM LIMIT/HOME SWITCHES
« on: November 13, 2017, 07:08:20 PM »
When I do an initial program/setup of the software for my cnc machine I don't get any response from the software.  I have set it up for both mm and inches and bach again without satisfaction.  i then found that after 24 hours the programming took affect.  I also don't seem to have control of direction of the y axis, instead of going positive to zero it goes negative and not matter what I set check marks in, it dosen't make a difference.  Also, my home switches, which are wired in parallel, don't work unless I press all three at once instead of individually.  They almost act as though they are wired in series like my limit switches except that when I press a limit switch all three led's light up as opposed to pressing one home switch and no led until all three home switches are pressed.  Limit switches work fine.  I got my break out board from 'Build your own CNC' and is for usb hookup.  I sincerely am in need of phone support.  Thanks.  630-879-9283.  Tom Stanfa 

Pages: 1