Hello Guest it is November 29, 2021, 04:49:40 AM

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - AndreiD

Pages: 1
General Mach Discussion / Re: Mach3 motor outputs issue
« on: February 20, 2018, 05:36:50 AM »
Tweakie thank you for reply, but after few install/uninstall of Mach3 , things return to normal.  I do not now where was the problem anyway.

General Mach Discussion / Mach3 motor outputs issue
« on: February 06, 2018, 03:33:16 AM »
Hello and please help.
  I have built a cnc plasma, it woks fine for a while with Mach3 trial. After I bought a license I installed Mach3 on a new Windows xp installation.  Now something  very strange is happening. My out pin assignment is like this ( for x 3-step 2-dir, y 5-step 4-dir,z 7-step 6--dir,  9-Output#1), but when I make a manual command on z azix ,Output1 activate, when I command x axis, z axis is moving instead, only Y axis is working fine.  I have change the PC and also interface board, but the result is the same. Inputs are functioning good. The machine is behave like this in any out pins configuration.

Thanks Craig, I did not pay attention to folders. Problem solved.

Hi,  I have a macro to zero z axis with floating head for my plasma table using G31 and probe imput. The macro is working fine from VB editor but I cannot trigger it from MDI or Gcode, it simply does nothing. I tried also with other simple macros, but none can be trigger. Default macros are working fine from MDI and also Gcode. Please help.

Thank You,

Pages: 1