1
FAQs / Re: touch plate guru brew plan- not getting mx4660 to cooperate
« on: January 10, 2019, 11:36:08 AM »
TPS-
It's working! I owe you a beer, my friend...
Best!
It's working! I owe you a beer, my friend...
Best!
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
ok had a look to the leadshine Manual.
you have to make a Bridge from the +12V out terminal to the OPTO2 teminal
and then you can use GND and Input3/4.