Guest
Show Posts
1
Mach4 General Discussion / MACH 4 C10BOB Pin Mapping
« on: September 29, 2017, 10:59:49 AM »
Hey little help here please
I have a licensed version of Mach4 Hobby and I am connecting to a C10 BOB via PMDX-411 Smart Bob.
When trying to map the X++ the only pin options are 1, and 14-17 but pins 2 through 9 are supposed to be the output pins yes?
Very new to this so any help would be much appreciated
I have a licensed version of Mach4 Hobby and I am connecting to a C10 BOB via PMDX-411 Smart Bob.
When trying to map the X++ the only pin options are 1, and 14-17 but pins 2 through 9 are supposed to be the output pins yes?
Very new to this so any help would be much appreciated